Wireless Remote Control; Maintenance And Storage; Technical Inspection - Pulsar ACCOLADE LRF XQ38 Instructions

21

WIRELESS REMOTE CONTROL

(bought separately)
Wireless remote control (RC) duplicates the power on function,
digital zoom, rangefinder control, and menu navigation.
Controller
(18)
Brief press Enter quick
menu
Long press Enter main
menu
Clockwise Increase
parameter,
rotation
move upwards
Counter- Decrease
clockwise parameter,
rotation move
downwards
22

MAINTENANCE AND STORAGE

Maintenance should be carried out no less frequently than twice a
year, and should consist of the following measures:
Wipe external plastic and metal surfaces clean of dust and dirt with
a soft cloth moistened with a synthetic cleaning agent.
Clean the electric terminals of the Battery Pack and device's battery
slot using a grease-free organic solvent.
Check the objective and eyepieces lenses; rangefinder's emitter
and receiver lenses. If required, remove dust and sand (preferably
by a noncontact method). Clean the external surfaces of the lenses
with products expressly designed for this purpose.
Store the device in a carrying case. Remove the Battery Pack
for long-term storage.
27
Button Button Button
ON (19) ZOOM (20) LRF (21)
Turn on Activate Activate
device / incremetal
rangefinder /
Calibrate zoom
Measure
sensor
distance
Display Off / Activate Activate
Turn off function PiP SCAN mode
device
20
19
18
23

TECHNICAL INSPECTION

Check:
External view (there should be no cracks on the housing).
The state of the objective and eyepiece lenses (there should be no
cracks, spot, dust, deposits etc.).
The state of the Battery Pack (should be charged) and electric
terminals (there should be no oxidation).
Correct functioning of the controls.
24
TROUBLESHOOTING
The table presented below lists some potential problems that may occur
when using the device. If a problem encountered with the device is not
listed, or if the recommended action does not resolve the problem, the
unit should be returned for repair.
21
Problem
The thermal imager
will not turn on.
The device does not
operate on external
power supply.
The device does not
operate on external
power supply.
Battery Pack is not
installed on the
device.
The image is blurry,
with vertical stripes
and uneven
background.
The image is too
dark.
Poor image quality /
Detection range
reduced.
Smartphone or tablet
PC cannot be
connected to the
device.
Check Corrective action
Battery Pack is discharged. Charge the battery.
USB cable is damaged. Replace USB cable.
External power supply is Charge the external power
discharged. supply (if necessary).
Stable operation of the Before using an external power
device with certain external supply, install the Battery Pack
power supplies (like power (it may be empty) on the
bank) is not guaranteed device. You can remove the
unless the standard Battery Pack once the device
IPS5/IPS10 Battery Pack is turns on.
installed.
Calibration is required. Carry out calibration according
to Section
"SENSOR CALIBRATION".
Brightness or contrast level Adjust brightness/contrast with
is too low.
the UP/DOWN buttons.
Problems described may arise in adverse weather conditions
(snow, rain, fog etc.).
Password in the unit was Delete network and connect
changed. again inserting the password
saved in the device.
There are too many Wi-Fi To ensure stable Wi-Fi
networks in the area where the performance, move the device
device is located which may to an area with few or no Wi-Fi
cause signal interference. networks.
28