Pulsar ACCOLADE LRF XQ38 Instructions page 10

Menu contents and description
Wi-Fi Wi-Fi ON/OFF
Press and hold down the М (3) button to enter the
Off =
main menu.
Select the desired menu option with the
=
UP (2) / DOWN (5) buttons.
Turn Wi-Fi on/off with a short press of the M
=
button.
Operating Selecting operating mode
mode
There are three automatic operating modes:
Each mode includes optimal combination of
parameters (brightness, contrast, gain etc.) to
deliver best possible image in specific viewing
conditions.
Press and hold down the М (3) button to enter the
=
main menu.
Select the desired menu option with the
=
UP/DOWN buttons.
Confirm your selection with a brief press of the M
=
button.
Enhanced contrast mode.
Rocks Perfect for viewing animals against the background
of rocks, ground in mountain areas.
Low contrast mode
Forest
Perfect for viewing animals against a background of
vegetation.
Universal mode for various modes of observation.
Identification
Color
Selecting colour palette
palettes
Basic image mode is "White Hot"
=
To select another palette:
=
Press and hold down the М (3) button to enter the
=
main menu.
Select the desired palette with the UP (2)/DOWN
=
(5) buttons.
Confirm your selection with a brief press of the M
=
button.
13
Black Hot palette (white colour corresponds to
low temperature, black colour – to high
temperature)
Red Hot
Red Monochrome
Rainbow
Ultramarine
Violet
Sepia
Switch between the palette selected in the menu
and the basic palette by holding down the
UP (2) button.
Selecting calibration mode
Calibration
There are three calibration modes: manual (M),
semi-automatic (SA) and automatic (А).
Press and hold down the М (3) button to enter the
=
main menu.
Select the desired calibration mode with the UP
=
(2)/DOWN (5) buttons.
Confirm your selection with a brief press of the M
=
button.
More details in the section "Sensor calibration".
Wi-Fi Wi-Fi setup
settings
This menu option allows you to set up your device
for operation in a Wi-Fi network.
This menu option allows you to set a password to
Password
access your thermal imager from an external
setup
device.
12345
The password is used to connect an external device
(i.e. smartphone) to your thermal imager.
Press and hold down the М (3) button to enter the
=
main menu.
Select the menu option with the UP (2)/DOWN (5)
=
buttons.
Press briefly the M button to enter submenu
=
"PAS".
The default password "12345" appears on the
=
display.
14