Stanley SCS-52 JET Mode D'emploi page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
G
B
operation ! This field can interfere with active or passive
medical implants under certain circumstances!
To reduce the risk of serious or fatal injury , we
recommend persons with medical implants their
physician and the manufacturer of the medical implant
consulted before the instrument is used !
Problem
The engine cuts out.
The engine starts but
delivers very little power.
The engine does not start or starts but
then cuts out again.
The engine runs unevenly.
Excessive smoke development.
Possible cause
Incorrect carburettor setting
Incorrect choke lever setting
Air filter dirty
Incorrect carburettor setting
Incorrect starting procedure
Incorrect carburettor setting
Sooted spark plug
Incorrect electrode gap on the
spark plug
Burned spark plug
Incorrect carburettor setting
Incorrect fuel mixture
18
Remedy
The carburetor can be adjusted by a
professional.
or
please contact service center.
Set it to
Remove the air filter, clean it with
soap suds, dry it and then fit it again.
Have the carburettor adjusted by a
specialist.
Follow the instructions in "Start when
the engine is cold"
Have the carburettor adjusted by a
specialist.
Clean the spark plug, correct the
electrode gap or replace the spark
plug.
Clean the spark plug, correct the
electrode gap (ideally 0.25"/0.63 mm)
or replace the spark plug.
Have the carburettor adjusted by a
specialist.
Empty the tank, and refill it with the
correct mixture: 2-stroke, ratio 40:1

Publicité

Table des Matières
loading

Table des Matières