Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- Wait until the engine is completely cold.
- Remove the air filter cover.
- Take the spark plug cap off the spark
plug and unscrew the spark plug using a spark
plug wrench.
- If the electrode has suered excessive wear or
it is heavily encrusted, the spark plug must be
replaced with an equivalent one. Heavy encrustation on
the spark plug may be caused by too high an oil content
in the fuel mixture, poor oil quality, the petrol mixture
being too old or the air filter being blocked.
- Screw the spark plug fully into the thread by
hand (do not cross the thread).
- Now tighten the spark plug using a spark plug
wrench.
- If you use a torque wrench, the tightening
torque is 12-15 Nm.
- Now attach the spark plug cap correctly to the
spark plug.
Fit the air filter cover again.
Chain lubrication
the fuel can be checked through the sight glass on the
fuel tank.
Important: please fill up the oil tank before refueling the
fuel tank every time.
Technical data
Air-cooled 2-stroke engine SPS1E46F
Displacement:
Max. engine power:
Fuel tank capacity:
Oil tank capacity:
Cutting length:
Spark plug:
NHSP LD/L8RTF, BOSCH/L8RTF
Weight ( Without guide bar and chain, empty tank):5,6 kg
Sound pressure level(L
Sound power lever(L
Vibration:
Max. front handle:
Max. rear handle
Length max. Bar:
Chain pitch:
Template chain:
Sprocket:
Engine idling speed:
Maximum speed:
Chain Type:
Guide Bar Type:
The operating noise level may exceed 115 dB.
Repairs
Use only the accessory and spare parts recommended by
the manufacturer. If the machine suers a failure despite
our quality controls and your care, have repair work
carried out only by a trained electrician.
Environmental protection
Do not simply dispose of the machine,
accessories and packaging in the dustbin, but
ensure that it can be recycled. A small
amount of effort on your part can do a great
deal of good for our environment.
Residual risks
Even when properly used in the tool is always some
residual risk that can not be excluded. From the nature
and design of the tool, the following potential hazards
can be derived :
- Contact with the unprotected chain ( cuts);
- Reaching into the running saw chain (cut injury);
- Unexpected , sudden movement of the guide rail ( cuts);
3
51,5 cm
- Ejection of parts of the chain;
2,1 kW
- Ejection of parts of the material to be cut;
3
500 cm
- Impairment of hearing , if there is no prescribed hearing
3
240 cm
protection is worn;
430 mm
- Inhalation of of material to be cut;
- Risk of kickback;
- This device produces an electromagnetic field during
17
):
102,89 dB(A), K=2,5 dB(A)
PA
):
111,68 dB(A), K=2,5 dB(A)
WA
2
7.256 m/s
, K=1.5 m/s
2
8.497 m/s
, K=1.5 m/s
450mm (18'')
8,255 mm
1,47 mm
7 Teeth X 8,255 mm
3050 min
11000 min
21LPX072X
188PXBK095
G
B
2
2
-1
-1
Publicité
Table des Matières
