Table des Matières
Publicité
3.3
Scope of delivery
– CMC III online comfort handle VX
– Accessories supplied loose (fig. 1)
– Installation and Short User Guide
3.4
Operating conditions
The comfort handle may only be operated under the following operating conditions:
Operating conditions
Temperature operational range
Humidity operational range
Degree of protection
4
Assembly
4.1
Assembly instructions
The assembly of the comfort handle is carried out as shown in fig. 4, fig. 5 or fig. 6.
Note:
Plug the connector with the long cables into the bottom of the jack. Plug the connec-
tor with the short cables into the top of the jack (see fig. 7).
5
Installation and operation
5.1
Operating and display elements
The operating and display elements are shown in fig. 2.
Key for fig. 2
1
Lever handle
2
Switch
3
Master key (semi-cylinder)
4
Multi-LED (ring)
5.2
Installation
Note:
Below, we describe how to connect the comfort handle to a base system including
Access Control. Information about connecting to an external controller via the PLC
interface can be found in the main operating instructions on www.rittal.com (see sec-
tion 1.1).
◾ First disconnect the CAN bus at the Access Control.
◾ Attach the appropriate handle to the door to be monitored (see section 4.1 "Assembly instruc-
tions").
◾ Connect this handle with the connection cable to the Access Control.
◾ Connect the reader unit with the connection cable to the Access Control.
◾ Reconnect the CAN bus to the Access Control.
Display of the status change:
Rittal CMC III online comfort handle VX
Product description, Assembly, Installation and operation
CMC III online comfort handle VX
+5 °C to +55 °C
5% to 70% relative humidity, non-condensing
IP 40 in accordance with IEC 60 529
EN
11
Publicité
Table des Matières
