Remote Control Layout; General Transmitter Layout; Temperature Display - Napoleon Oakville Série Manuel Du Propriétaire

4.1

general transmitter layout

note:
The remote control is optional.
The receiver switch must be in the REMOTE position for the transmitter to function. This remote system operates
using radio frequency signals sent by the transmitter to the receiver. It is recommended that the distance between
the transmitter and receiver never exceeds 20' and 10' if the receiver is located within the fi replace's outer or inner
cavity surrounding an insert. Low batteries will also affect operational distance.
4.2

temperature display

Remove the battery cover on the back of the transmitter to expose the °C /
°F dip switch. Move the dip switch to your desired temperature mode.
Selected temperature mode will appear in the top right corner beside the
room temperature.

4.0 remote control layout

EN
11
W415-4002 / 08.11.21