TFA 35.1116 Mode D'emploi page 12

TFA_No_35.1116_Anl_ 31.01.2012
CULT – Wireless Weather Station
Indoor temperature
Tendency indicator
A 3: Lower display
Radio-controlled time (DCF) with seconds/weekday and date
Radio-controlled reception symbol DCF
In case battery symbol for base station and alarm symbols
B: Buttons (Fig. 2):
B 1: ▲ button
B 2: ▼ button
B 3: mode button
B 4: mem button
B 5: alarm button
B 6: channel button
C: Housing (Fig. 2):
C 1: Battery compartment
D: Transmitter (Fig. 3):
D 1: Holder for wall mount
D 2: Indentations for the holder
D 3: Holder for table standing
D 4: Battery compartment
6. Getting started
Insert batteries:
• Place both instruments on a desk with a distance of approximately
1.5 meter. Check that no other electronic devices are close.
• Remove the holder of the transmitter and slide the battery compart-
ment lid downwards. Remove the insulation strip. Place the battery
compartment lid on the housing and slide it upwards.
• Pull off the protection foil on the display of the station. Open the
battery compartment of the weather station by pushing the battery
compartment lid downwards with your thumbs. Remove the insula-
tion strip. Place the battery compartment lid on the housing and slide
it upwards.
22
21:04 Uhr Seite 12
CULT – Wireless Weather Station
Reception of outdoor temperature
• The basic unit automatically starts scanning the 433 MHz signal to
register the thermo sensor unit after batteries are inserted. The unit
will scan (for 2 min.) the outdoor values.
• If the reception of outdoor values fails, "- -" appears on the display.
Check the batteries and try it again. Check if there is any source of
interference.
• Manual initialization can be helpful. Press and hold ▼ button for 2
seconds. The station will only select an outdoor transmitter on the
actual selected channel.
• There are 3 different reception icons:
- reception is active
- reception is successful
- no reception (1 hour)
Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol
flashes on the LCD. When the time code is received successfully after
3-8 minutes, the radio-controlled time is displayed and the date and
the DCF symbol are displayed steadily in the LCD. During the DCF
time reception period, no outdoor data will be transmitted.
• There are 4 different reception icons:
- reception is active
- reception is very good
- reception is weak
- no reception in the last 24 hours / time is set manual
No icon - reception is deactivated (press and hold ▲ button for 2 sec.)
• Press and hold ▲ button again for 2 seconds, to activate the reception
manually.
• If the clock cannot detect the DCF-signal (for example due to distur-
bances, transmitting distance, etc.), the time can be set manually.
23