Offseason Storage; Troubleshooting - Maytronics Dolphin W 20 Mode D'emploi

8. OFFSEASON STORAGE

If the Pool Cleaner will not be in use for an extended period, perform the following storage steps:
• Disconnect the Pool Cleaner from mains
• Make sure that no water is left in the Pool Cleaner
• Thoroughly clean the filter bag or cartridges and insert in place
• Roll up the cable so that it has no kinks and place on the Caddy
• Store the Pool Cleaner upright on the Caddy or simply upside down in a protected area
out of direct sun / rain / snow at a temperature of between 5°-45°C / 41°-113°F

9. TROUBLESHOOTING

Before contacting your W 20 distributor please read through this guide.
Symptom
Cable twisting or cable coils up
W 20 is moving in circles or does not
reach all pool areas
Remote control is not working
Motor is not working
Additional troubleshooting is available at our Website: www.maytronics.com
Robotic Pool Cleaner W 20
Solution
Check for any obstruction in the pool
Remove excess cable from the pool
Make sure filter bag / filter cartridge is clean
Straighten cable and lay it in the sun periodically
Check for foreign objects in moving parts
Make sure filter bag / filter cartridge is clean and well
mounted and that the filter doors are closed
Make sure that there is enough cable laid out to cover the
whole pool
Before using the W 20 at the beginning of the season you
should brush any algae from the floor and walls of the pool
Check if the batteries need replacing
Check if the impeller is blocked
Check if the drive system is blocked
Electrical problem (power supply), check power source.
If power source is in order, please contact your W 20
distributor
User Instructions
|
11