Removal From The Pool And Storage; Troubleshooting - Maytronics Dolphin Hybrid RS 1 Mode D'emploi

Removal from the Pool and Storage

❙ ❙
When you choose to remove the
Dolphin Hybrid Cleaner from the
pool:
1 Ensure to switch the pool
pump OFF.
2
Disconnect the Skimmer
Adapter from the suction line
opening.
3 Disconnect the Safety Valve.
4 Disconnect the Hose Sections,
pulling them slowly one-by-
one out of the pool.
5 When you reach the section
connected to the
Hybrid Cleaner
Dolphin Hybrid Cleaner handle
and remove the Dolphin Hybrid Cleaner from the pool (Drawing J).
CAUTION
6
Store the
out of direct sunlight. Do not store the
Cleaner
frost. Make sure that Hose Sections are in a straight
position (Drawing K).
7 For longer life of the equipment, it is recommended
to rinse the
water.
8
Reopen all skimmers.

Troubleshooting

❙ ❙
The Dolphin Hybrid Cleaner is designed to operate with a minimum of user maintenance.
If a problem does occur, try to determine the cause. Often, the solution is already part of the
standard operating instructions in this booklet. If you cannot solve the problem easily, contact your
supplier.
Dolphin Hybrid RS 1 - Suction Pool Cleaner
_book_8151171_Dolphin_Hybrid_v2.indb 7
Dolphin
, grasp the
Remove the Dolphin Hybrid Cleaner from the pool only by its handle!
and Hose Sections
Dolphin Hybrid Cleaner
where it will be exposed to excessive heat or
Dolphin Hybrid Cleaner
|
J
K
Dolphin Hybrid
and parts with tap
Operating Instructions
7
17/6/2012 1:34 PM