Time Zone Setting; Display Change; Alarm Setting; Temperature Alarm Setting - Bresser ClimaTemp FW Mode D'emploi

15 Time zone setting

To set a different time zone, proceed as follows:
1. Press and hold MODE button for approx. 3 seconds to change to time setting mode.
2. Press the MODE button multiple times until the display shows the time offset 00 Hr.
3. Press UP or DOWN button to select the desired time deviation in hours (-23 up to +23 hours).
4. Finally press the MODE button to save the settings and exit the setting mode.

16 Display change

In normal display mode, press the DOWN/RCC button to toggle the time display between 12-hour or
24-hour mode (AM/PM time information is displayed or hidden accordingly)
In normal display mode, press the UP/CF button to toggle between °C and °F when displaying the
temperature unit.
In normal display mode, press the CH button several times to display channels 1, 2, 3 or automatically
alternating one after another.
NOTICE! The display of values for different channels requires the connection of several suitable
wireless sensors (not included).
In normal display mode, press the ALERT button several times to display the set temperature alarm
values one after another.

17 Alarm setting

1. Press MODE button to switch to alarm time display.
2. Press and hold ALARM button for approx. 2 seconds to enter the alarm time setting mode (AL).
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press ALARM button to confirm and continue to the next setting.
6. Settings order: Hours > Minutes
7. Finally press the ALARM button to save the settings and exit the setting mode. Alarm will be activ-
ated automatically. The
8. Press MODE button in normal display mode to display the alarm time.
9. Press ALARM button during the alarm time display to disable the alarm. The
displayed.

18 Temperature alarm setting

1. In normal time display mode, press DOWN button for approx. 2 seconds to enter temperature
alarm time setting mode.
2. Digits to be set are flashing.
3. Settings order: ON/OFF (Temperature alarm on/off) > Temperature highest limit > Temperature
lowest limit > Exit
4. Press UP or DOWN button to change the value.
5. Press SET button to confirm and continue to the next setting.
6. The temperature settings mode will be quit automatically after 30 seconds of inactivity. All settings
done before will be saved.
7. When outdoor temperature reaches highest or lowest limit, the temperature alarm symbol will flash
and an alarm will sound for approx. 3 seonds. This will be repeated with an interval of 1 minute un-
til the temperature has fallen below the limit again.
symbol will be displayed.
symbol will not be
27 / 80