Switching On/Off; Selecting Functions And Adjusting Settings Direct Selection - Bosch Professional Line 3 CCD Mode D'emploi

Switching on/off | Selecting functions and adjusting settings

Switching on/off

Function Action
Switch on/off f Press the ON button
f Switch the vehicle
f Switch microphone 1
Note:
Whilst the vehicle ignition is on, the
system will switch on automatically
for an incoming call if a telephone is
present that is connected directly or
via Bluetooth®.
Selecting functions and adjusting settings
Direct selection
Important and frequently used functions can
be selected directly by pressing a button on the
CCS/CCD. In order to select certain functions,
it is necessary to keep the corresponding
button pressed down longer (approximately 3
seconds).
Robert Bosch Car Multimedia GmbH
1
ignition on/off
(MIC1) on/off
Note
When the vehicle ignition is off, the system
switches off automatically after 1 hour to
conserve the vehicle battery.
The system will only switch on together with
the vehicle ignition if it was previously
switched off together with the vehicle
ignition.
Only when the vehicle ignition is switched
on.
The system will only switch off together with
microphone 1 (not included in the scope of
delivery) if it was previously switched on
together with microphone 1.
Note:
In order to use the functions of
certain buttons for the cabin, you
must first switch the focus of control
over to the cabin.You will find further
information about the focus of control
in the "Focus of control" section in
this chapter.
en | 43
02.2012