Invacare Aquatec Pure Bidet Manuel D'utilisation page 9

1. Press AUTO button F on the remote control.
• The 3rd level for water pressure, the 2nd level for
warm air dryer temperature and the last setting of
nozzle position are automatically set-up.
• The Sensor forces to set the water- and seat
temperature to "Medium", in case the temperature
were set up on the "High" position.
• A buzzer sounds when the auto cleansing function
finishes.
2. Press STOP button B on the remote control.
• The automatic cleansing process is interrupted.
3. Press AUTO button F again.
• The previous automatic cleansing process is
resumed.
Automatic cleansing function: Move cleansing and
warm air dryer run for 1 minute each.
Setting water pressure
The water pressure can be set in three steps (indicated by
first, middle and last LED):
1. Press CLEANSING/MOVE button C on the remote control.
2. Press HIGH respectively LOW button J on the remote
control.
• The water pressure of the cleaning nozzle is raised
or lowered by one step and displayed on the LED A.
The last set value of the water pressure is
automatically saved by the device.
Setting nozzle position
1. Press FRONT respectively BACK button I during
cleansing function on the remote control.
• The cleansing nozzles move forwards respectively
backwards.
When the cleansing process is complete and you
move away from the seat, the nozzle moves back into
the last setting of the nozzle position.
Setting water temperature
The water temperature can be set in four steps:
1. Press WATER button H repeatedly on the remote control,
until the desired temperature is reached.
• The water temperature is displayed on the LED
display above.
If the cleaning functions are repeatedly started, the
water temperature drops gradually. To regain the
desired water temperature, suspend the cleaning
function for three minutes. The last value of the
water temperature is automatically saved by the
device.
Setting seat temperature
The seat temperature can be set in four steps:
1590625-F
1. Press SEAT button G repeatedly on the remote control,
until the desired temperature is reached.
• The seat temperature is displayed on the LED
display above.
The last value of the seat temperature is automatically
saved by the device.
The seat is equipped with an internal combustion protection
system. If the seat temperature is set to "High" and you
remain longer than 30 minutes on the seat, the seat
temperature drops automatically. As soon as you leave the
seat, the temperature returns to the setpoint.
Setting warm air temperature
The warm air temperature can be set in five steps:
1. Press DRY button E on the remote control.
2. Press HIGH respectively LOW button J on the remote
control.
• The temperature of the warm air dryer is raised or
lowered by one step and displayed on the LED A.
The last value of the warm air dryer temperature is
automatically saved by the device.
Turning on/off night-light LED
1. Press LIGHT button M on the units control panel.
• The night-light is activated when it gets dark in the
room.
When the night light is activated, the device
automatically recognizes the toilet light and the night
light is turned off. The user can conveniently bidet
without toilet light. The power consumption of the
night-light is very low.
2. Press LIGHT button again to switch off the night-light.
Automatic power saving mode
1. Press POWER SAVING button L repeatedly, until "AUTO"
LED Q illuminates.
• Seat temperature is automatically set at 30 °C
Auto power saving function is temporarily released,
when sitting on the seat. Auto power saving function
runs again, when moving away from the seat.
2. Press POWER SAVING button twice.
• Power saving mode deactivates and "AUTO" LED
turns off.
Super power saving mode
Bidet senses toilet luminosity for itself and shows excellent
power saving function.
9