Invacare Aquatec Pure Bidet Manuel D'utilisation page 8

Aquatec® Pure Bidet
5.2 Using the unit control panel and remote
control
O P Q R
N M L
C
B
Overview of key functions on remote control
Pos.
Key name
WATER / DRY
A
STOP
B
C CLEANSING/MOVE
D BIDET/MOVE
DRY
E
AUTO
F
SEAT
G
WATER
H
I FRONT / BACK
J HIGH / LOW
HIP BATH
T
S HIGH / LOW
BATTERY SIGN
U
Overview of key functions on control panel
Pos.
Key name
CLEANSING/STOP
K
POWER SAVING
L
LIGHT
M
LIGHT SENSOR
N
8
K
D
I I E
S A S
Function
Display of the current water
pressure or the temperature
of the warm air dryer
Stops all active functions
Cleansing function is
performed
Bidet function is performed
Warm air dryer function
begins to operate
Automatic cleaning function
starts
Adjusting seat temperature
Adjusting water temperature
Change nozzle position
Adjusting warm air dryer
temperature
Adjusting water pressure
Hip bath cleansing is
performed
Display of current water
temperature or seat
temperature
Illuminates when batteries
need to be replaced
Function
Device turns off
Power-saving mode activates
Night-light activates
When night-light function is
activated, bidet automatically
senses toilet light and
night-light LED switches on
Overview of key functions on control panel
Pos. Key name
POWER
O
LIGHT
P
AUTO
Q
SUPER
R
5.3 Using the shower toilet
Perform manual cleansing
A sensor is located inside the toilet seat, that is only
activated by skin contact.
1. If plugged-in, the device is turned on and the "POWER"
LED O illuminates on the control panel.
• If the "POWER" LED does not illuminate, press any
button on the remote control (except HIGH/LOW
or FRONT/BACK buttons).
2. Set yourself centered on the toilet seat.
3. Press the CLEANSING/MOVE button C or BIDET/MOVE
button D.
• CLEANSING respectively BIDET-function is performed.
4. Press again CLEANSING/MOVE button or BIDET/MOVE
button during the cleansing process.
• The cleansing nozzle moves back and forth. Nozzle
stops by pressing the button again.
5. Press STOP button B on the remote control.
• Shower procedure stops.
6. Press DRY button E on the remote control.
• Warm air dryer is activated. Dryer function stops by
pressing the "STOP" button.
7. Press CLEANSING/STOP button K and hold for more
than 4 seconds.
• The device is turned off — All displays switch off on
the control panel.
CLEANSING/MOVE and BIDET/MOVE function operates
for 90 seconds. Hip bath function operates for 3
minutes. DRY function operates for 3 minutes. The
functions are ending with an audible beep. Before
and after each operation, the self nozzle cleaning
function runs and sanitizes the nozzle head.
Perform automatic cleansing
The automatic cleansing function is a default function for
people with disabilities, children or the elderly, in which a
complete cleansing cycle is automatically executed.
Function
Illuminates when unit is
switched on
Illuminates when night-light is
activated
Illuminates when automatic
power-saving mode is
activated
Illuminates when super
power-saving mode is
activated
1590625-F