Installation / Assembly - Invacare Aquatec Pure Bidet Manuel D'utilisation

A
B
C
D
E
Catch plate
A
Brackets (2x)
B
Fixation bolts (2x)
C
Washers (2x)
D
E Packing nuts (2x)
F PVC Flexible hose (for main unit)
T-valve
G
Batteries for remote control
H
Remote control and holder
I
3.4 Functional description of the self-cleaning
mechanism
The self-cleaning mechanism of the showering and cleansing
nozzle is automatically activated before and after each
function / use.
The showering and cleansing nozzle is automatically retracted
and rinsed with fresh water for approx. 5 seconds. Since
the shower and cleansing nozzle is at this time within the
device, water cannot be splashed when the lid is open.
When pressing a function key, the nozzle moves out again
and is ready for use.
When the device has been in standby-mode or has
been re-connected to the power supply, the self-cleaning
mechanism is activated once.
4 Setup

4.1 Installation / Assembly

Assembling the shower toilet
The Aquatec Pure Bidet fits standard and norm-WCs.
WARNING!
Risk of being scalded by hot water
– Only connect the shower toilet to a cold water
supply.
WARNING!
– Check all the accessory parts are in place.
– Do not connect the power until installation is
finalized.
The shower toilet is suitable for all types of water
supply connection with a flushing cistern (top,
bottom, sideways).
If the T-valve does not fit onto the water supply,
adapter pieces are necessary.
1590625-F
F
H
I
G
C
B
1. Unfasten the fixation nuts B of the existing toilet seat
A underneath the toilet bowl.
2. Remove the toilet seat and keep it with the fixation
parts B and C for later use.
A
1. Close the shut off valve A clockwise.
2. Drain toilet water tank completely by flushing.
A
C
B
1. Detach the water supply hose A on the part of the shut
off valve B.
2. Mount the T-valve C between shut off valve and water
supply hose.
If part A is a rigid pipe, it must be replaced by a
flexible hose.
A
B
1. Press lever A to detach the holder plate B from the
bidet.
A
5