Cordless Remote Mode (Remote); Meter-Feet Changeover (M/Ft); Secondary Reflector - Metz MECABLITZ 58 AF-1 digital Mode D'emploi

Once the Zoom Size mode is activated, „SZoom" will appear on the display
next to the focal length.
Refer to your camera's instruction manual for further information.

7.6 Cordless remote mode (Remote)

• When „Remote OFF" appears, the cordless remote mode is deactivated.
• When „Remote Master" appears, the flash unit is operating as a guiding
master flash unit on the camera.
• When „Remote Slave" appears, the flash unit is operating completely as a sla-
ve flash unit. See also Section 21.
Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the „Remote" menu option by pressing the UP
tons. The selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
takes effect immediately.
• Press the „Return" button repeatedly until the screen is reset to its normal
view. If the „Return" button
reset to its normal view after about 5 seconds.

7.7 Meter-Feet changeover (m/ft)

The maximum flash range indicated by the flash unit's display can either be
shown in meters or feet. The setting can be adjusted under the menu option
m/ft. Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the „m/ft" menu option by pressing the UP
The selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
takes effect immediately.
and DOWN
and DOWN buttons. The setting
is not pressed, the display is automatically
and DOWN
and DOWN buttons. The setting
- When „m" is displayed, distances will be shown in meters.
- When „ft" is displayed, distances will be shown in feet.
• Press the „Return" button
state. If the „Return" button
reset to its normal view after about 5 seconds.

7.8 Secondary reflector

The secondary reflector
ting when the main reflector
If the secondary reflector
or 1/4 .
• „ Off" setting: Secondary reflector is turned off.
• „ P1 / 1" setting: secondary reflector is operating at full light output.
but-
• „ P1 / 2" setting: secondary reflector is operating at 1/2 light output.
• „ P1 / 4" setting: secondary reflector is operating at 1/4 light output.
When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Setting procedure:
• Press the „SEL" button repeatedly until „Select" appears on the display.
• Select the menu option
selected menu option will be highlighted.
• Confirm the selection of the special function by pressing the „Set" button.
• Select the desired setting with the UP
takes effect immediately.
• Press the „Return" button
state. If the „Return" button
buttons.
reset to its normal view after about 5 seconds.
Please also refer to the information in Section 10.3!
repeatedly until the display is reset to its normal
is not pressed, the display is automatically
is used for frontal brightening in the case of indirect ligh-
is pivoted to the side or upwards (see 10.3).
produces too much light, it can be reduced to 1/2
by pressing the UP and DOWN
and DOWN buttons. The setting
repeatedly until the display is reset to its normal
is not pressed, the display is automatically
buttons. The
103