Hella Comet FF 100 Instructions De Montage page 10

10
Accessories, see Fig. page 6
(not included with kit)
Tools required:
Mounting steps:
Please Note:
For a satisfactory paint finish,
please have the headlamp
housing (material PC) painted in a
specialist paint shop.
1. Two-point mount
2. Wiring harness with relay
• Ruler
• Combination pliers
• 10 mm open end or box
wrench
For mounting pendant/upright
above or below bumper. Lamp
should not vibrate or extend above
the bonnet and must be attached
symmetrically.
1. Determine mounting position
and mark mounting points.
2. Drill pilot hole with 3 mm dia. bit
and then bore out to 6,5 mm.
Protect drilled metal parts with rust
protection paint.
3. Protective grille
• 5 mm Allen Keys
• Drill with 3/ 6,5/ 12 mm dia. bits
• Insulating tape
3. Remove lamp set, press rubber
grommet in from inside and install
stabilization ring (Fig.1; 2).
4. Preinstall bracket (Fig. 3) and
assemble with housing depending
on desired position (Fig. 4).
Tighten bolts hand-tight.