RugDoctor 93308 Manuel D'utilisation page 19

SETTING UP/ GET READY TO CLEAN
DO NOT USE BOILED OR MICROWAVED WATER IN TANK. Doing so could
result in scalding or burns.
Do not overwet the carpet. Use luke warm water on wool and wool blend
carpets. DO NOT USE on natural fibre, silk or pure wool oriental rugs, hand
loomed wool rugs, braided rugs, sisal, sea grass matting or jute carpets, silk,
haitian cotton, brushed corduroy, leather, non colourfast fabrics, berber,
Flotex, Ryalux carpets, wood effect laminate flooring. Doing so could
damage material and void warranty on machine. Do not walk on wet carpet.
Your RUG DOCTOR PORTABLE SPOT CLEANER is ready to start cleaning right out of
the box. No assembly required! Follow these simple instructions to start cleaning.
1. Fill the CLEAN WATER TANK:
a. Simply lift the CLEAN WATER TANK straight up from the unit.
b. Unscrew the cap and pull the nozzle to remove the tube from the tank.
c. Add hot tap water, filling to the CLEAN WATER line marked on the top of the
tank. Only use luke warm water on wool/wool mix carpets. DO NOT BOIL OR
MICROWAVE THE WATER.
d. Pour RUG DOCTOR PORTABLE MACHINE SPOT CLEANER solution into the
tank, filling to the "Spot Cleaner" line marked on the tank. Each 120ml fill is the
equivalent of just over a third of a coffee mug full.
e. Insert the tube back into the tank, replace the outer cap and tighten.
f. Replace the tank by setting it straight down into the unit, pressing down firmly
until it feels secure.
2. Lift the MOTORISED BRUSH from the unit and completely unwrap the flex hose
from around the hose retainers.
3. Rotate the power cable retainers on the back of the unit to release the power
cable and unwrap completely. Plug into a mains socket.
HOW TO CLEAN / FEATURES
You're now ready to deep clean spots and stains on carpet, upholstery
and hard to clean places such as stairs and vehicles. Your RUG
DOCTOR PORTABLE SPOT CLEANER has innovative features; A
powerful MOTORISED BRUSH to clean deep down and WHEELS and a
RETRACTABLE "LUGGAGE STYLE" HANDLE to make getting to the stain
easier than ever before.
MOTORISED BRUSH
1. With the unit powered on, position the MOTORISED BRUSH well in front of the stain or
area you want to deep clean.
2. Turn ON the MOTORISED BRUSH by pressing power switch to the "ON" position.
3. Squeeze and hold the SPRAY trigger to begin cleaning. Slowly move the tool over the
stain, releasing the SPRAY trigger at the end of the cleaning process. For dried-in or
deep down stains, make multiple passes, but do not overwet the carpet or upholstery
you are cleaning.
4. Excess water can be removed by making additional passes with the tool without
squeezing the SPRAY trigger. This will allow faster drying time and avoid overwetting.
5. Leave machine on for 15 seconds after cleaning to allow all of the dirty solution to be
collected into the WASTE WATER TANK.
36 UK 01903 23 55 58 EIRE 1800 93 20 96
ALWAYS CHECK FOR COLOURFASTNESS.
WHEELS & RETRACTABLE "LUGGAGE STYLE" HANDLE
1. To lift the RETRACTABLE HANDLE press down on the HANDLE
RELEASE button while lifting the handle upward.
2. Tip the unit back and pull to manoeuver easily around your home.
3. To retract the handle, press down on the HANDLE RELEASE
button pushing the handle downward until completely recessed
into the unit.
EMPTYING THE WASTE WATER TANK
1. Empty the WASTE WATER TANK when the dirty water reaches the "Full Line"
2. Remove the WASTE WATER TANK from the unit by pulling the tank forward and
lifting it straight up. The inlet on the side of the tank is now open so it is important
to KEEP IT UPRIGHT while you go to the sink or toilet to dispose of the dirty
water.
3. Over a sink or toilet, turn the tank on its side and allow the dirty water to pour out
of the inlet.
4. In order to clean the WASTE WATER TANK, unscrew the WIDE OPENING LID.
Remove the WIDE OPENING LID and float column from inside the tank and set
aside.
5. Remove any debris in the tank and around the filter and rinse the inside of the
tank.
6. Replace the float column and the WIDE OPENING LID, firmly tighten the cap.
7. Replace the WASTE WATER TANK by setting it straight down into the unit,
pressing down firmly until it feels secure.
REFILL THE CLEAN WATER/SOLUTION TANK
1. Simply lift the CLEAN WATER TANK straight up from the unit.
2. Unscrew the cap and pull the nozzle to remove the tube from the tank.
3. Add RUG DOCTOR PORTABLE MACHINE SPOT CLEANER formula to the
"SPOT CLEANER" fill line shown at the bottom of the tank. Each 120ml fill is the
equivalent of just over a third of a coffee mug full. Add hot tap water, filling to the
"Clean Water" line marked on the tank. Only use luke warm water on wool/wool
mix carpets. DO NOT BOIL OR MICROWAVE WATER.
4. Insert the tube into the tank, replace the cap and tighten.
5. Replace the tank by setting it straight down into the unit, pressing down firmly
POWERFUL, until it feels secure.
MOTORISED
BRUSH
FOR A DEEP
DOWN CLEAN
After you've used your RUG DOCTOR PORTABLE SPOT CLEANER follow these easy
steps for quick clean-up and storage of your unit.
1. Unplug the power cable from the mains socket and wrap it around the power
cable retainers.
2. Wrap the flex hose around the hose retainers and replace the MOTORISED BRUSH
on the unit.
3. Empty the CLEAN WATER TANK (if necessary), rinse and replace on the unit.
4. Empty the WASTE WATER TANK then rinse, clean and dry before placing back on
the unit. The WIDE OPENING LID tank opening is designed to allow your hand to
fit inside to thoroughly clean, rinse and dry, for a fresh clean tank.
5. Store the handle in the recessed position for compact storage.
6. Keep in a protected, dry area at room temperature. IMPORTANT: DO NOT
EXPOSE THE UNIT TO TEMPERATURES BELOW 4
(110 o F).
HOW TO CLEAN / FEATURES (CONT)
CLEANING UP & STORAGE AFTER USE
UK 01903 23 55 58 EIRE 1800 93 20 96
CARPET
FRIENDLY
WHEELS,
EASY TO
MANOEUVER
C (40 F) AND ABOVE 43 C
o o o
37