Pre-Operation Checks - Honda HRS536C4SKEA Manuel De L'utilisateur

There is one adjustment lever [1] for each wheel.

PRE-OPERATION CHECKS

ARE YOU READY TO MOW?
Be sure to wear protective clothing. Long pants and eye protection
can lower your risk of injury from thrown objects. Wear footwear that
protects your feet and won't let you slip if you mow on slopes or
uneven ground.
CHECK YOUR LAWN
For your safety and for the safety of others, always inspect the area
before mowing.
Objects
Anything that can be picked up by the cutting means and thrown is a
potential hazard to you and others. Look for things like stones, sticks,
bones, and wire. Remove them from the mowing area.
People and Pets
People and animals near the mowing area can move into your path or
into a position where they could be struck by thrown objects. Clear the
area of people, especially children, and pets. Their safety is your
responsibility.
Lawn
Check the length and condition of the grass, so that you will know
what cutting height and mowing speed to use.
Avoid mowing wet grass. Not only will wet grass clog your mower
deck and collect in clumps on the lawn, it also gives poor traction,
increasing your risk of losing your footing.
CHECK YOUR MOWER
Cutting Means
1. Move the fuel valve to the
OFF position (page 4).
2. Disconnect the spark plug cap
from the spark plug (page 12).
3. Tilt the mower to the right so
the fuel cap is up [1]. This will
help prevent fuel leakage,
motor oil seeping into the air
filter, and hard starting.
[1]
[1]
4. Inspect the cutting
means [2] for damage,
cracks, and excessive
wear, rust, or corrosion.
A worn, cracked, or damaged cutting means can break,
and pieces of the damaged cutting means can become
dangerous projectiles.
Thrown objects can cause serious injury.
Inspect the cutting means regularly, and do not operate the
mower with a worn or damaged cutting means.
A dull cutting means can be sharpened, but a cutting means that is
worn out, bent, cracked, or otherwise damaged must be replaced. A
worn or damaged cutting means can break, causing cutting means
pieces to be thrown from the mower.
NORMAL WORN
When a cutting means needs sharpening or replacement, take the
lawnmower to an authorized Honda dealer. Or, if you have a torque
wrench, you can remove and install the cutting means yourself.
Check that the cutting means bolts [2] are tight (page 13).
ENGLISH
[2]

WARNING
CRACKED
BENT
NORMAL
EXCESSIVELY
WORN
5