Klarstein HOT SPOT CRYSTAL Mode D'emploi page 22

EN
Switch on
First, set the power switch of the device, which is located on the side of the device, to the
„I" position. Press the button to set the function. The upper part of the control panel
displays the room temperature. The unit will now run at a low power level.
Mode
Press the Mode button to adjust the power.
Temperature adjustment
Press the temperature button to set the desired temperature in the range 5 °C - 40 °C.
Each time the appliance is started, the indoor temperature is displayed. When the indoor
temperature reaches the temperature you set, the unit will switch from high to low power.
If the room temperature is at least 2 °C higher than the set temperature, the unit stops
operating. As soon as the temperature drops by 2 °C again, the unit resumes operation,
depending on the set target temperature.
Timer
The timer can be set to automatically switch the unit on or off at a desired time. A time
interval between 1 and 24 hours can be set.
Parental lock
If you press and hold the parental control button on the remote control for 3 seconds,
all buttons are disabled. You can deactivate the parental control in the same way. If you
do not have the remote control at hand, you can press and hold the heat button on the
control panel for 5 seconds to lock/unlock the screen.
22