McCulloch CS 42S Mode D'emploi page 4

a WARNING! Always disconnect spark plug
wire and place wire where it cannot contact
spark plug to prevent accidental starting
when setting up, transporting, adjusting
or making repairs except carburettor
adjustments.
INTRODUCTION
A chainsaw is a high-speed wood-cutting tool. Special
safety precautions must be observed to reduce the
risk of accidents.
Failure to follow all safety rules and precautions can
result in serious injury.
If situations occur which are not covered in this
manual, use care and good judgment. If you need
assistance, contact your authorized service dealer or
call customer support.
PLANNING AHEAD
Read this manual carefully until you completely
understand and can follow all safety rules,
precautions, and operating instructions before
attempting to use the unit.
Restrict the use of your saw to adult users who
understand and can follow safety rules, precautions,
and operating instructions found in this manual.
Wear protective gear. Always use steel-toed safety
safety chaps; heavy-duty, non-slip gloves; eye
protection such as non-fogging, vented goggles
or face screen; an approved safety hard hat; and
hearing. Regular users should have hearing checked
regularly as chainsaw noise can damage hearing.
Secure hair above shoulder length.
Keep all parts of your body away from the chain
when the engine is running.
Keep children, bystanders, and animals a minimum
not allow other people or animals to be near the
chainsaw when starting or operating the chainsaw.
Do not handle or operate a chainsaw when you are
fatigued, ill, or upset, or if you have taken alcohol,
drugs, or medication. You must be in good physical
condition and mentally alert. Chainsaw work is
strenuous. If you have any condition that might be
aggravated by strenuous work, check with your
doctor before operating a chainsaw.
Carefully plan your sawing operation in advance.
4
SAFETY
Do not start cutting until you have a clear work
area, secure footing, and, if you are felling trees, a
planned retreat path.
OPERATING YOUR SAW
Do not operate a chainsaw with one hand. Serious
injury to the operator, helpers, bystanders or any
combination of these persons may result from
one-handed operation. A chainsaw is intended for
two-handed use.
Operate the chainsaw only in a well-ventilated
outdoor area.
Do not operate saw from a ladder or in a tree.
Make sure the chain will not make contact with any
object while starting the engine. Never try to start the
saw when the guide bar is in a cut.
Do not put pressure on the saw at the end of the
cut. Applying pressure can cause you to lose control
when the cut is completed.
Stop the engine before setting the saw down.
Do not operate a chainsaw that is damaged,
improperly adjusted, or not completely and securely
assembled. Always replace bar, chain, hand guard,
or chain brake immediately if it becomes damaged,
broken or is otherwise removed.
Exposure to vibrations through prolonged use of
petrol powered hand tools could cause blood vessel
people prone to circulation disorders or abnormal
swellings. Prolonged use in cold weather has been
linked to blood vessel damage in otherwise healthy
people. If symptoms occur such as numbness,
pain, loss of strength, change in skin color or
joints, discontinue the use of this tool and seek
medical attention. An anti-vibration system does not
guarantee the avoidance of these problems. Users
who operate power tools on a continual and regular
basis must monitor closely their physical condition
and the condition of this tool.
With the engine stopped, hand-carry the chainsaw
bar and chain to the rear, preferably covered with a
scabbard.