Erreka VIVO-M203M Guide Rapide D'installation Et Programmation page 14


The opening and closing limit switch must be installed before programming the travel (see
the operator manual).
8
Start opening of leaf 1
with ST1:
11
Start opening of leaf 2
with ST1:
14
Start closing of leaf 2
with ST1:
17
Start closing of leaf 1
with ST1:
20
U141O
14
Programming travel (all cases)
6
C701 C702
With ,
00 CA00,
and the gate carries out
the approach operation (opens for
4 seconds and then closes to
programme the closing point). It
a l s o c a r r i e s ou t s o f t s t op i n
accordance with the CA value.
In other cases, close the gate
before starting programming.
9
Start slowdown of leaf 1
with ST1 (only with CA01
or CA02):
U241G
12
Start slowdown of leaf 2
with ST1 (only with CA01
or CA02):
U141K
15
Start slowdown of leaf 2
with ST1 (only with CA01
or CA03):
U141N
18
Start slowdown of leaf 1
with ST1 (only with CA01
or CA03):
U241T
21
A6 K
and/or
10
Finish opening of leaf 1 with ST1:

In any case, this is carried
out automatically when
the opening limit switch
is reached (with C701,
C703, C704 or C705) or
the FCA (with C702 or
C704).
U141I
13
Finish opening of leaf 2 with ST1:

In any case, this is carried
out automatically when
the opening limit switch
(with C701, C703, C704
or C705) or the FCA
(with C702 or C704) is
U141L reached.
16
Finish closing of leaf 2 with ST1:

In any case, this is carried
out automatically when
the closing limit switch
(with C701, C703 or
C704) or the FCC (with
C702, C704 or C705) is
reached.
U241R
19
Finish closing of leaf 1 with ST1:

In any case, this is carried
out automatically when
the closing limit switch
(with C701, C703 or
C704) or the FCC (with
C702, C704 or C705) is
reached.
U241U

The anti-trapping safety system continues to run during
programming operations.

Pedestrian opening is programmed using F3, meaning it is
not necessary to record this pedestrian opening travel.

Whenever an obstacle is detected during programming
in up-and-over operation with the C5 closing photocell
activated, this will be taken as the point from where to
U141P
activate the photocell shadow area. Only works with
Collective Opening (A901).

The procedure with a
swing gate is shown
below.
Proceed in a similar
manner for sliding gates
and up-and-over doors.
U241J
U241M
U241S
U241V