Print In Color; Set The Print Quality - Rimage PrismPlus! Manuel D'utilisation

Print in Color

Install a multicolor ribbon in the printer. Refer to the
1.
2. Access Print Properties. Refer to page 18.
3. Select the Device Settings tab.
4. Select the Installed Ribbon setting.
5. Select Color, Three Panel CMY from the dropdown list.

Note: The Double Print selection is disabled when a color ribbon is selected. Double print is not available during the
color printing process.
6. Select the Media Type.
7. Select the Print Strobe setting and set the value anywhere in the range of 375 to 425.

Notes:
•
These are recommended settings for Rimage brand media.
•
This may require multiple test printings on discs to fine-tune the color hue. Set Enable Color Sub-Strobes to
Enabled to lower an individual color's print strobe. For example, this setting can be used to lower the Yellow
Print Strobe setting when trying to eliminate a halo effect on a printed disc.
8. If this is a standalone printer, disable Perfect Print option. This option is only available on select Rimage autoloaders.
9. Select Halftone Setup Properties to make changes that affect color intensity, color balance, or pattern settings.
10. Select OK to save the changes and close the Rimage Perfect Image Printer PF Properties window.

Set the Print Quality

1. Access Print Properties. Refer to page 18.
2. From the General tab, select Printing Preferences. The Rimage Perfect Image Printer PF Printing Preferences window
opens.
3. Select Advanced. The Rimage Perfect Image Printer PF Advanced Options dialog box opens.
4. Select the resolution.
5. Select OK. The Rimage Perfect Image Printer PF Advanced Options dialog box closes.
6. Select OK. The Rimage Perfect Image Printer PF Printing Preferences window closes.
7. Select OK to save the changes and close the Rimage Perfect Image Printer PF Properties window.
110635_K
Operate the Prism Printer
Change the Print Ribbon section on page 24.
19