Clean The Print Head - Alternate Method - Rimage PrismPlus! Manuel D'utilisation

cleaning pad.
4. Clean the print head.
a. Press the operator button to close the printer tray
and start the cleaning cycle. When the cleaning
cycle is complete, the printer tray opens.
b. If necessary, repeat step a to begin the cleaning
cycle again.
c. When the print head is clean, remove the cleaning
pad and attached disc from the printer tray.
5. Clean the front two ribbon guides.
a. Apply isopropyl alcohol to a clean cotton swab.
b. Run the swab against the ribbon guides to clean
them.
Prepare the Prism for use.
6.
a. Press the power switch off and on to exit cleaning mode and reset the printer.
b. Reinstall the ribbon. Refer to the
c. If you removed the printer form an autoloader or AutoPrinter, place the printer on the system and connect all cables
and cords. Refer to the

Note: If the printing pad on the tray is wet from cleaning, allow the printing pad to completely dry before using the
Prism.
Clean the Print Head – Alternate Method
If a cleaning kit is not available, use the following procedure to clean the Prism print head.
Required tools:
#
•
99% Isopropyl alcohol
•
Cotton swabs
1. Prepare the Prism.
a. Power on the Prism.
b. Press the operator button to open the printer tray.
c. Power off the Prism.
d. Remove the top cover.
e. Remove the ribbon. Refer to the
110635_K
Change the Print Ribbon
Identify the Parts of the Prism Printer
Change the Print Ribbon
Maintain the Prism Printer
section on page 24.
section on page 11.
section on page 24.
Front Ribbon
Guides
Cleaning Pad
Cleaning
Solution
23