Setting Ribbon Type, Media Type, And Print Strobe; Setting Color Options - Rimage PrismPlus! Perfect Image Manuel D'utilisation

Setting ribbon type, media type, and print strobe

1. Navigate to printing properties.
2. Select the Device Settings tab.
3. Select the type of Installed Ribbon.
Note: The Double Print feature allows you to print the same label twice on the disc. If you
would like the printed areas on your discs to have more density, enable Double Print. Using
Double Print will consume more ribbon.
4. Select the Media Type.
5. Set the Master Print Strobe:
•
To achieve optimum print results for monocolor printing, set the Master Print Strobe to
350 ms.
•
To achieve optimum print results for color printing, set the Master Print Strobe to 400 ms.
•
To increase the printhead life, set the Master Print Strobe to the lowest setting that
provides satisfactory printing.
6. To Enable Color Sub-Strobes, select Enabled.

Setting color options

Printing in monocolor
1. Install a monocolor ribbon in the printer. Refer to Changing the print ribbon on page 18.
2. Navigate to printing properties.
3. Select the Device Settings tab.
4. Select the Installed Ribbon setting and select Monocolor.
5. Select the Master Print Strobe setting and set the value from the table below.
Media Surface
DVD or Regular
Thermal white
overcoat
6. Select the Detect Media Change option.
•
If you are using a Rimage autoloader, select No.
•
If you are making multiple copies on a standalone PrismPlus, select Yes.
Note: When the Detect Media Change option is enabled, you must press the
operator button after you remove the printed disc and place a new disc on the tray.
7. Disable the Perfect Print option. This option is only used for the Rimage AutoPrinter.
8. Select the Media Type.
9. To save the changes, select OK.
110635_H
Print strobe Print strobe
setting for black setting for red
ribbon ribbon
325 - 400
350 - 400
Operate the PrismPlus
Print strobe
setting for blue
ribbon
375 - 425 350 - 400
375 - 425 350 - 400
13