Rimage PrismPlus! Manuel D'utilisation page 29

Rimage PrismPlus! User Guide
5. Load the take-up roller.
a. Place the new empty cardboard core on the take-up
roller. It is designed to fit only one way.
b. Place the take-up roller on top of the ribbon leader as
shown.
-
Important! The gear must be on the correct side.
c. Pull the ribbon leader up over the cardboard core.
d. Attach the adhesive strip to the cardboard core so
that the edges on the ribbon leader are aligned to the
edges of the cardboard core.

Note: The arrow in the photo illustrates the wrap
direction.
e. Roll the ribbon leader so that it is wrapped only once
around the roller.
-
Important! Do not roll past the marking on the
leader that states STOP - Wind Leader Onto
Take-up Core Stopping here.
6. Install the take-up roller in the Prism and press down
firmly until the take-up roller snaps into place. The ribbon
should be tight and there should be no creases in the
ribbon.
-
Important! Do not roll the STOP - Wind Leader Onto
Take-up Core Stopping here marking on the ribbon
leader onto the take-up roller. The marking should not
be past the point shown in the picture. If the marking
is on the roller, pull the take-up roller out and roll back
the ribbon. Roll the supply roller back to take up the
slack.
7. Press the operator button. The printer tray closes.

Note: During the ribbon validation process, the
ribbon cycles past the ribbon leader. After the ribbon
validation process is complete, make sure that the
ribbon is wound tight.
8. Install the top cover.
9. Make sure the printer is set for the type of ribbon installed.
Refer to Set Color Options
26
on page 18.
Gear
Adhesive Strip
Take-up Roller
Ribbon Leader
Cardboard Core
Ribbon Leader
Marking
110635_K