Rimage PrismPlus! Manuel D'utilisation page 28

2. Load the print ribbon.
a. Slide the print ribbon onto the supply roller.
b. Align the two notches of the cardboard core to the metal pins on
the supply roller.
c. Peel the ribbon leader from the supply ribbon.
d. Slide the ribbon leader under the ribbon guide.
3. Tape the ribbon leader to the back of the printer tray as shown.
4. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the operator button until the printer tray comes out. The
ribbon is threaded to the front of the Prism.
b. Remove the tape from the printer tray.
c. Remove the adhesive strip from the ribbon leader.
110635_K
Maintain the Prism Printer
Print Ribbon
Cardboard Core
Metal Pins
Supply Roller
Tape Ribbon Guide
Printer Tray Ribbon Leader
Supply Roller
Notches
25