Finishing; Decorative Panels; Ax36 Log Placement - Napoleon Altitude X Serie Manuel D'installation

Bumpout Under Log
Notch
(Not Illustrated)
Bumpout Under Log
(Not Illustrated)

9.0 finishing

finishing
EN
4
WARNING
2
!
2
• Risk of fire!
• Never obstruct the front opening of the appliance.
5
• The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specified dimension, as illustrated.
Notch
• Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
• Facing and/or finishing material must never overhang into the appliance opening.
• The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
9.1

decorative panels

Notch
This appliance does not include decorative brick panels, however, panels are required. Panel kits are sold sepa-
2
rately. Consult your local authorized dealer / distributor. Refer to the 'replacement parts' section.
9.2

AX36 log placement

5
Notch
2
WARNING
!
NOTE: Notch on
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
Back Side of Log
with this appliance may result in property damage or personal injury.
(Not Illustrated)
9
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
Charcoal Detail
• The logs are fragile and should be handled with care.
PHAZER logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is dif-
TM
5
ferent in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log
colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pigments
burn in during the heat activated curing process. Blocked burner ports can cause an incorrect flame pattern.
7
6
Driftwood log set (AX36)
2
8
8
Notch
7
2
9
8
Refer to leaflet provided with kit for log placement instructions.
38
W415-1935 / G / 05.10.22
Angled
1
3
1
3
2
5
1
4
C1
4
2
3
2 3
Bumpout Notch
Bumpout Under Log
Notch
(Not Illustrated)
6
1
1
6
5 8
3
5
6
1
7
2
2
4
4
4 1
5
4
3
2
3
Knob
1
4
2
6
6
3
5
1
4
4 1
5
2
3
3
6
5
1
4
10
3
Maple log set (AX36)
Bumpout Under Log
Notches
(Not Illustrated)
Edge
1
C2
NOTE: Notch on
Back Side of Log
(Not Illustrated)
3
5
7
Notch
Split Branch
5
7
7
7
9
7
9
Angled
1
4
2
4
5
2
Notch
1
2
6
6
5
1
4
4
2
Knob
Notch
1
2
6
4
5
1
48.1
4
6
Oak log set (AX36)
2
8
Birch log set (AX36)
Edge
3
1
3
3
7
3
Knob
Split Branch
3
8
7
7
3
Notch
9