Bestway 58515 Manuel Du Propriétaire page 9

are accessible for operation, servicing and
winterizing.
3. EN60335-2-41 TEST standard requires the
sand filter to be vertically fixed on ground or a
certain pedestal made of wood or concrete
before use to prevent the sand filter from
accideutally falling. Fully assembled sand filter
will exceed 18 kg. The mounting holes should
be 8 mm in diameter and spaced 285 mm apart. Use two bolts and
nuts with a maximum of 8 mm in diameter to fasten the sand filter to
the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE: Use only special pool-grade filter sand, free of all limestone or
clay: #20 Silica sand 0.45-0.85 mm, approximately one 8.5 kg bag
should suffice. If you do not use the recommended size filter sand,
filtering performance will be reduced and the sand filter may
damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour
some water into the Bottom Tank to submerse the Skimmer on the
Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
C
C
9
Ø8 mm
285 mm
MAX.
MIN.
C
C