Bestway 58515 Manuel Du Propriétaire page 13

RCD TEST
1
AIR RELEASE
Press down the control valve handle and wait untill the water flow
from Port D to release the air.
NOTE: It is important to repeat this operation every time you start
the pump after winterizing, maintenance and backwashing the sand
bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the pump for
its first use and to wash the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and
rotate to the Backwash function.
2. Plug in and run the sand filter for 3-5 minutes,
or until the water runs clear.
3. Switch off the sand filter and set the Control
Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This circulates
water backwards through the sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
you'll need to replace.
Switch off the sand filter immediately if water levels near the pool's Inlet
and Outlet valves.
This procedure removes water from the pool, which
2
13
3
Backwash
4
Rinsing