Fine Adjustment Of The Upper Grinding Mechanism - Graef CM 800 Mode D'emploi

Clean the lower and upper grinding mechanism with the brush
•
enclosed.
PUSH
After cleaning, first
•
of all place the grin-
ding ring back on
to the motor block
(arrow pointing to
arrow).
Note: In order to test whether the grinding mechanism has been set
in correctly, turn the grinding ring to "coarse", such as level 35, and
try to pull out the grinding mechanism by the metal ring. If the grin-
ding mechanism cannot be removed, it has been installed correctly.
Place the coffee bean container on the unit.
•

FINE ADJUSTMENT OF THE UPPER GRINDING MECHANISM

By means of the fine adjustment of the upper grinding mechanism,
you can set the grinding degree to coarser or finer.
Proceed as follows:
Remove the upper grinding mechanism.
•
Use a screwdriver to remove the small screws.
•
Turn the grinding mechanism one stop to the right (coarser) or left
•
(finer).
Note: Set the grinding mechanism two to three stops to the right or
left maximum at first.
Screw the screws back in again.
•
Place the upper grinding mechanism back in again.
•
24
Now place the up-
•
per grinding mecha-
nism.
PUSH
Turn the grinding
•
ring clockwise to
the requested grin-
ding degree