Troubleshooting - Dometic CAM 1000 Instructions De Montage Et De Service

Troubleshooting

The test indicator allows the camera to be correctly aligned with the front of the vehicle. The refer-
ence line (fig. b 1) shall be at least in alignment with the front of the vehicle. The active area
(fig. b 2) is marked as a red area in the video for 6 seconds.
I
NOTE
In night mode with ambient lighting below 50 lux, the camera switches to black and
white mode. This is necessary to optimize object detection even in poor lighting con-
ditions.
The CAM1000 / BSC01 is automatically activated at a speed of less than 40 km/h.
As soon as objects move in the same direction and faster as the vehicle, the dynamic arrow indica-
tor (fig. b 3) appears in the display. If the audible signal is connected, an evenly repeating beep
will sound.
8.3 Operation at day and night
The monitor M75LXAHD from the BSV71000 system offers adjustment possibilities to adapt the
image to day and night operation. These settings must be made before connecting the blue wires.
➤ For more information, please refer to the manual of the monitor M75LXAHD.
9 Troubleshooting
Fault
The device shows no
function.
"NO SIGNAL" is dis-
played on the monitor.
A yellow GPS icon
appears on the monitor.
12
Cause
The black or red cable for the
voltage supply are not making
contact.
The system plug is not con-
nected or not correctly plugged
into the control electronics.
No video signal present. Loose
contact in the plug connector of
the camera cable
The camera is defective.
CAM1000 was not connected to
camera input C3.
GPS reception is faulty.
CAM 1000 / BSC 01
Solution
Check that the connections are
secure.
Check the system plug and make
sure that it locks into place.
Check that the connections are
secure.
Contact an authorized service
center to replace the camera.
Make sure that CAM1000 is con-
nected to camera input C3.
The system is active but the
acoustic warning signal is off until
a better GPS reception is
obtained.
EN