Air Pressure And Temperature Sensor - Beta Motorcycles RR 350 EFI 2019 Mode D'emploi

2) rotate the safety device as shown;
3) remove the connector.
For re-assembly, proceed opposite the
above-mentioned order.
AIR PRESSURE AND
TEMPERATURE SENSOR
Remove the tank (page 80).
The connector is positioned as indicated
in figure.
1) press the lock device;
2) Pull the connector upwards.
For re-assembly, proceed opposite the
above-mentioned order.
Attention: at the end of the operation en-
sure that the connector is blocked.
71
CLICK
4
EN