Beta 601CA Mode D'emploi page 7

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
DIGITAL TORQUE AND ANGLE GAUGE ITEM 601CA
OPERATION MANUAL AND INSTRUCTIONS FOR THE DIGITAL ANGLE GAUGE MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The digital gauge can be used for the following purpose:
• measuring the right-hand/left-hand torque or angle on screws and nuts in combination with ratchets
or levers.
The following operations are not permitted:
• the digital gauge must not be used in humid or wet environments, and must not be exposed to heat,
rain or snow
• the maximum capacity of the gauge must not be exceeded
• the digital gauge must not come into contact with chemical and corrosive substances
• the digital gauge must not be used for any applications other than recommended ones.
WORK AREA SAFETY
Do not operate the digital gauge in environments containing potentially explosive atmospheres,
because sparks may be generated, which can ignite the dust or fumes.
Keep children away from the digital gauge.
Do not use the digital gauge near flammable material.
DIGITAL GAUGE SAFETY
• Before use, check that the digital gauge has not been damaged, and that no parts are worn.
• Do not force the electronic circuit of the digital gauge.
PERSONNEL SAFETY
Stay alert; watch what you are doing. Do not use the digital gauge while tired or under the influence of
drugs, alcohol, or medication.
BATTERY INSTALLATION/REPLACEMENT
Install or replace the batteries as follows.
•
Loosen the four screws of the battery compartment on the back.
601CA.indd 7
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE
DIGITAL GAUGE. FAILURE TO COMPLY WITH THE SAFETY STANDARDS
AND OPERATING INSTRUCTIONS MAY RESULT IN SERIOUS INJURY.
.
EN I
7
08/09/16 10:54