Beta 601CA Mode D'emploi page 10

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
TORQUE MEMORIES MENU
• This menu provides the values of the measured and stored torque or angle (up to 50 values stored).
• If no values have been stored in the menu, the display will show nonE.
• The display will show the stored torque value for each memory area (n005<--> 20.3°).
• Press buttons
• To delete one of the stored values, press button (C) twice in the memory area.
• To quit the menu, press button (U/S) several times.
RESETTING TORQUE MEMORIES MENU
• This function allows all the values stored in the TORQUE MEMORIES menu to be deleted.
• The display will show ClrA
• To delete all the stored values, press button (C): the display will show no?
• To delete all the stored values, press button (C) again. To cancel the operation, press button (U/S).
• To quit the menu, press button (U/S) several times.
TIGHTENING COUNT MENU
• The device will store the torque at a torque value equal to, or higher than, 60% of its maximum capacity.
• The count cannot be reset until the next calibration.
• For example, if the display shows (n-0 <--> 0160) , it means that 160 torque values have been set.
If it shows (n-1 <--> 2500), it means that 12,500 torque values have been set.
• To quit the menu, press button (U/S) twice.
ERROR MESSAGES
• Er0 > indicates that the gauge has been subjected to a driving torque higher than 110% of the maximum
value.
• Er4 > indicates that the value has not been set correctly. Press button (C) to repeat the operation.
Do not move the gauge while setting it.
• Er5 > indicates that the gauge is not working correctly. Proceed with the RESET.
• Er---> indicates that the gauge was rotated too quickly during a measurement. Press button (C) to repeat
the operation.
• Full > indicates that no data can be stored in the memory because the memory is full. Delete some
of the 50 stored data.
RESET
• The gauge can be reset by removing the batteries.
MAINTENANCE
Maintenance, repair and calibration jobs must be carried out by trained personnel only. For such jobs,
you can contact Beta Utensili S.P.A.' s repair centre.
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be
collected separately from other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
• deliver it to an appropriate collection facility for electronic and electrotechnical equipment;
• return it to the dealer upon purchase of a new, equivalent item of equipment;
• in case of a product for professional use only, contact the manufacturer which will arrange for the
product to be properly disposed of.
Proper disposal of this product allows the raw materials contained in it to be reused and prevents da-
mage to the environment and human health.
Illegal disposal of this product is a violation of the provision concerning the disposal of hazardous waste
and will give way to the application of such fines as provided for under current regulations.
10
601CA.indd 10
and to select the stored values.
EN I
08/09/16 10:54