Nuova Simonelli AURELIA WAVE S Manuel D'instructions page 12

Masquer les pouces Voir aussi pour AURELIA WAVE S:
Table des Matières

Publicité

for human consumption. The installer must Make the hydraulic connections
respecting the rules of hygiene and water safety to environmental protection
in force in the place of installation. So for the hydraulic plant contact an au-
thorized technician. Always utilise the new hose supplied for connection to the
water supply. Old hoses must not be utilised.
On installation, the qualified electrician must fit a circuit breaker switch as
foreseen by the safety norms in force that has a contact open distance that
permits the complete disconnection under conditions of overload category III.
For Australia, the above must be done according to the AS / NZS 3000 installa-
tion standard.
In case of installation in kitchens, connect the equipotential conductor to the
terminal on the machine indicated by the symbol .
[symbol IEC 60417 - 5021
(2002-10)]
There are some basic rules for the use of any electrical appliance. In particular:
Never touch the unit with wet hands or feet;
Never use the unit with bare feet;
Never use extension cords in areas equipped with baths or showers;
Never pull on the power supply cord to unplug the unit;
Never leave the unit exposed to atmospheric agents (rain, direct sunlight,
etc..);
Never let children, unauthorized personnel or anyone who has not read this
manual operate the unit.
The qualified electrician must also check that the section of the installation's
cables is large enough for the absorbed power of the appliance.
Never use adapters, multiple jacks or extension cords. When such items prove
absolutely necessary, call in a qualified electrician.
To prevent dangerous overheating, it is advisable to fully extend the power
supply cord. Never block the intake and/or heat dissipation grills, in particular
those for the cup warmer.
The user must never replace the unit's power supply cord. If this cord is dam-
aged, turn off the unit and have it replaced by a professionally qualified tech-
nician.
12
equipotentiality
The manufacturer cannot be held responsible
for any damages incurred if the system is not
grounded.
For electrical safety, this machine requires a
ground system. Contact a technically certified
electrician who must check that the line electri-
cal capacity is adequate for the maximum capac-
ity indicated on the unit label.
AURELIA WAVE S-V

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aurelia wave vAurelia wave s-v

Table des Matières