Fitting Your Cat Fl Ap - Petsafe Staywell 500 Série Guide De L'utilisateur

Fitting your cat fl ap
Your Staywell ® cat flap is fitted with the red 4 way lock on the
inside of your house.
Temporarily place the cat fl ap in the hole and position the outside cover on
the outside of the house. From the outside mark screw holes through the
holes in the outside cover. (Fig 5.).
Remove the cat fl ap and drill the holes with a 4.5mm (
FIG.5
Replace the cat fl ap in the hole and from the outside screw into place. (Fig. 7).
If the screws are too long they may need to be cut down to match the
depth of your door. Using over long screws may damage the cat fl ap. The
screws should be removed from the cat fl ap before cutting. File down to
ensure there are no sharp edges.
Push fi t the 4 way locking turning dial into place (Fig. 7).
Finally, cover the screw holes with the blanking plugs on the outside frame
to ensure a neat fi nish (Fig. 7).
5
3 / ") drill bit (Fig. 6).
16
FIG.6
FIG.7
If fi tting into glass, the cat fl ap is 'clamped' to the glass
using two screws from the outside of the house.