Manual Operation - Petsafe Staywell 500 Série Guide De L'utilisateur

Attaching the Infra-red collar key
The key must be attached to the collar so that it hangs forwards (Fig. 17).
FIG. 17

Manual operation

Please note, this feature CANNOT
been fully powered and programmed. If you do not wish to use the
electronic latch the cat fl ap can be placed in manual mode.
Remove the battery cover by pushing in the direction of the arrows.
Press the manual button once (Fig. 18). and the latch will unlock and the
LED fl ashes. The cat fl ap is now in manual mode.
To place the cat fl ap back in
automatic mode press the
manual button. The latch will
relock and the LED fl ashes.
The cat fl ap is now back
in automatic mode.
9
be used until the cat fl ap has
FIG. 18
Low battery power
Cat fl ap
When the batteries are starting to run low, the LED will fl ash RED every 2
seconds until the battery runs dead.
Remove the battery cover by pushing in the direction of the arrows.
Remove the old batteries and insert 4 x new AA 1.5V Alkaline Long Life
FIG. 19
Collar key
As the power in the collar key batteries runs low you will notice a loss
of range as your cat approaches the door. Eventually the battery power
will become so low that the cat door will not open and the LED will stop
fl ashing. To restore power, replace the two batteries in the collar key and
refer to "Powering the Infra-red key".
batteries. (Fig. 19). Replace
battery cover. Your cat fl ap
will retain all programming.