Disc Margin; Connecting Laboforce-3; Supplying Power; Communication - Struers LaboForce-3 Manuel D'instructions

Disc Margin

Connecting LaboForce-3

Supplying Power

Communication

4
LaboForce-3
Instruction Manual
Before the final tightening of the nut you must check the margin
between the holes of the specimen mover plate and the edge of the
grinding/polishing disc. The distance should be:
Diameter of the
Holes
40 mm
1½"
1¼"
30 mm
25 mm
Having adjusted the disc margin, tighten the nut firmly.
The column should now remain in position.
 Connect the power cable to the socket on the back of the
LaboPol machine, .
Check that the mains voltage corresponds to the voltage stated on the type
plate on the back of the machine.
LaboForce-3 is provided with a communication cable. Connect the
plug to the socket on the back of LaboPol, .
To enable communication between LaboForce-3 and LaboPol, set
the switch  to 'on'.
Disc Margin
1.5 mm
2.5 mm
6.0 mm
6.5 mm
9.0 mm
IMPORTANT
IMPORTANT