HumanTechnik lisa timeflash Mode D'emploi page 7

We would like to congratulate you on
the purchase of our lisa time flash
and hope that it will serve you well for
a long time to come. You have
chosen a mo dern and reliable
system. Please read through the ope-
rating instruction carefully to be able
to start the unit correctly and to fami-
liarize yourself with all of the system
features.
The lisa time flash is an electronic
clock with an analogue time display.
It wakes you up with a flashing light
and/or an acoustic alarm. The follo-
wing special accessories can be
connected to the alarm clock:
- Vibrating pillow
- Flash module
- Switch module
- Acoustic module.
In addition, the lisa time flash has a
receiver for the lisa signaling system.
Standard components
Please check if all following compo-
nents are included:
- lisa time flash
- 230 V power supply unit
- Operating instructions
- Warranty card
Startup
Connect the supplied mains lead to
the socket on the alarm clock and
plug it into a 230 V power outlet.
Time setting
Carefully pull out the button for set-
ting the clock/alarm time and, with
the button pulled out, turn it in the
direction of the arrow until the de-
sired time is set.
Note: Please do not use excessive
force when pulling out the button for
setting the clock/alarm time!
Alarm setting
Turn the button for setting the
clock/alarm time in the direction of
the arrow until the required alarm
time is set.
Switching on the alarm
Switch on the alarm using the ON/OFF
switch.
Switch not pressed: Alarm switched
on (green out line visible around
switch).
Switch pressed: Alarm switched off.
Switching on the audible alarm
Switch on the audible alarm using the
audible alarm ON/OFF switch.
Switch not pressed: Audible alarm
switched on (green out line visible
around switch).
Switch pressed: Audible alarm swit-
ched off.
Snooze Alarm
Press the Light/Snooze button to sus-
pend a alarm which is in progress.
The alarm is triggered again after
about 4 minutes.
English 7