Cleaning Instructions - Tristar VE-5951 Mode D'emploi

OPERATION
The power switch is incorporated in the speed control switch on the top of the fan.
•
The fan can operate in oscillation or static mode.
•
To make the fan head oscillate, push down the Oscillation Knob.
•
To stop the fan head from oscillating, pull-up the Oscillation Knob.
•
The head of the fan can be adjusted up or down, to do this loosen the adjusting knob, adjust
the fan to the desired angle, to secure tighten the adjusting knob.
THERMAL CUT-OUT DEVICE
A Thermal protector device was mounted in the motor. When overheats due to various reasons, the
temperature of the motor reaches the fusing point, it will cut off automatically, make the fan safe
efficiently. When the protector is fused, the fan should be eliminated trouble and replace a new
thermal protector before the fan is used again.

CLEANING INSTRUCTIONS

•
Be sure to unplug the fan from electrical supply source before cleaning.
•
Plastic parts should be cleaned with mild soap and a damp cloth or sponge. Thoroughly remove
soap film with clean water.
•
To disassemble each part, reverse the order of assembly.
Guidelines for protection of the environment
This appliance should not be put into the domestic garbage at the end of its useful life, but must be disposed of at a central point for
recycling of electric and electronic domestic appliances. This symbol on appliance, instruction manual and packaging puts your attention to
this important issue. The materials used in this appliance can be recycled. By recycling used domestic appliances you contribute an
important push to the protection of our environment. Ask your local authorities for information regarding the point of recollection..