Tristar VE-5951 Mode D'emploi page 12

Partslist
ASSEMBLY
If your fan comes ready assembled ignore this part.
1. After removing everything from the carton, locate the motor unit (item 8) and
separate the front guard (item 2) and back guard (item 5) if they are connected.
2. Locate the rear guard (item 5) and align with 4 protruding indents on the motor unit
(item 8). The safety grille will only fit one way over the pro-truding intents with the
handle facing up. insert 4 locking screws (item 4) and tighten to secure the rear guard
to the motor unit.
3. Locate the fan blades (item 3) and align the centre of the blades over the metal spindle
protruding from the motor unit. The intent on the metal spindle aligns with the locking
screw on the fan blades. After the blade has been put on, tighten the locking screw on
the fan blades and ensure that the blades is secured to the motor unit.
4. Align the front guard to the rear guard and lock into place with 3 locking tabs that are
located on the guard. Locate the security nut and bolt (item 1) and secure the front
and rear guards together with security nut and bolt. This is a safety precaution to
prevent the accidental dismantling of the fan.
5. Locate the pedestal base of the fan(item 13). Insert the base of the stand (item 10)
into the pedestal base,then fasten the base(item12,13) and the pole with the screws
provided.
6. Undo the thumbscrew at the top of the stand(item 10) and align the motor unit
complete with guards before fastening.
BASE AND TUBE ASSEMBLY
Take the base and tube parts from the packing box and loose the 4 joint screws. Fix the tube on the
base plate by the joint screws.
1.Screw, nut
2.Front guard
3.Blade
4.Position screw
5.Rear guard
6.Power switch
7.Oscillation Knob
8.Motor
9.power cord
10.Tube
11.Joint screw
2.Base Addition part
13.Base