Setting Program Start Time(S); Program Looping Feature - Irritrol IBOCPlus Guide D'utilisation

SETTING PROGRAM START TIME(S)

This procedure is used to set the watering cycle start time(s) for each
program. A maximum of eight start times per program can be assigned.
Each start time will initiate a sequential watering cycle of all stations
with an assigned run time in the program.
Note: It is important to remember that a start time initiates the entire
watering program cycle, not an individual station.
PROGRAM LOOPING
The Program Looping feature enables a watering program to start and
run consecutive repeat cycles until a predetermined stop time is reached.
Each program can have one loop operating cycle assigned in addition to
eight regular start time assignments. If a program loop is not assigned, the
display shows "Loop Strt Off."
To set program cycle start times and/or program loop time:
1. Turn the function dial to the
position.
LOOPING
2. Select Program
3. Use the +/ or –/
ON
4. Press the
NEXT
5. Use the +/ and/or –/
ON
Note: To remove a start time, adjust the time to display "Off"
which is located between 11:59 p.m. and 12:00 a.m.
6. Press the
NEXT
eight start times for the selected program.
7. Press the
NEXT
8. Use the and/or
+/
ON
9. Press the
NEXT
Use the and/or
10. +/
ON
11. Press the
NEXT
8 through 10 to set the loop stop time.
12. Repeat steps 2 through 11 for each program as necessary.
13. When finished, return the function dial to
Programming the Controller
PROGRAM CYCLE START TIMES/
or with the
,
A B C PROGRAM
button to adjust the start time hour.
OFF
button to select the minutes digits.
button to adjust the start time minutes.
OFF
button and repeat steps 3 through 5 to assign up to
button to display "Loop Strt."
button(s) to adjust the loop time hour.
–/
OFF
button.
button(s) to adjust the loop time minutes.
–/
OFF
button to display "Loop Stop" and repeat steps
button.
AUTO RUN.
13