Star TCP300II Série Manuel D'utilisation page 56

Appendix C: Optional Ethernet Interface IFBD-HE05/07
LED
<Initializing Settings>
To initialize the setting information, set the push switch as described below.
Push the switch for 1 to 5 seconds while the unit is operating in the normal mode. The
green and red LEDs will flash with a regular pattern.
In this state, momentarily push the switch once again to turn OFF both the green and
red LEDs. This will revert the interface board to its factory settings. After the interface
board has been initialized, the unit will automatically reboot itself.
<LED Display>
Green (100M): Lights when the port is operating at 100 Mbps.
Red (Link/Activity): Lights when the link is made between the port and the connected
<Connecting the Ethernet Cable>
1. An Ethernet cable is not included with the unit. Please provide a cable that is
appropriate for the specs.
2. If a ferrite core is included, install the ferrite core onto the ethernet to prevent elec-
trical noise. If a ferrite core is not included, perform step 3.) only.
For details on how to attach the ferrite core, see the installation sheet that is sup-
plied with the Ethernet board.
3. Insert the Ethernet cable into the interface board connector.
Push switch
device, and mutual communication is enabled.
IFBD-HE05
IFBD-HE07
– 53 –
Ferrite core