Installation - Kärcher BD 70/75 W Classic Bp Manuel D'utilisation

Hose switch
17
Fresh water tank filling hole
18
Suction bar
19
Suction bar height adjustment
20
Suction bar inclination adjustment
21
Wing nuts for fastening the suction bar
22
Suction hose
23
Fresh water filling level display
24
Fresh water drain hose
Cleaning head lever
25
Water volume regulation knob
26
Suction bar lever
27
Battery plug connector
28
Key-operated switch
29
Display
30
Working speed rotary knob
31
Travel direction switch
32
Waste water tank drain hose with dosing unit
33
Transport holder for suction bars
34
** Not in scope of delivery
Color coding
 Control elements for the cleaning process are yellow.
 Control elements for maintenance and servicing are
light gray.
Symbols on the device
Fresh water tank drain opening
Waste water tank drain opening
Increased cleaning head contact pressure
Battery access
Fresh water tank filling level (50%)
Insert the charger plug here
Eyelet point
* Mop holder
ATTENTION
Incorrect socket
Risk of damage
DO NOT insert the charger plug here
Normal cleaning head contact pressure
Raise the cleaning head
Pedal for raising/lowering the cleaning head
Brush replacement pedal
* optional
1. Remove the carton.
2. Remove the straps.
3. Remove the wooden blocks fastened to the pallet by
screws.
4. Put a ramp in front of the pallet using the 3 upper rein-
forcement boards from the carton packaging and the
safety board screwed across the pallet and fasten with
particle board screws.
Safety board
1
Squared timber
2
Reinforcement board
3
5. Push the squared timber unscrewed from the pallet un-
der the ramp for support and screw tight.
6. Press the cleaning head lever downwards and engage
it towards the right.
7. For BD 80/100 only: Press the brake lever down.
Brake lever
1
Note
There is no brake for BD 70/75. Releasing the brake is not
necessary with this device.
8. Pull the device backwards off the pallet.
9. For BD 80/100 only: Press the brake lever up.
Installing the suction bar
1. Insert the suction bar in the suction bar mount.
2. Tighten the wing nuts.
3. Fit the suction hose.
English

Installation

Unloading
1
7