Preventing unnecessary recording (VAS)
When VAS (Voice Activated System) is set, if silence continues for approx. 2 seconds during recording,
the recording is paused automatically.
• When the unit is not in the stop state, press
[g STOP/RETURN].
1
Press [MENU/FOLDER].
2
Press u, i to select "VAS" and
press [q OK].
3
Press +, – to select "
[q OK].
(The factory setting is "
To exit the setting screen, press
[g STOP/RETURN].
To start VAS recording, press [* REC].
If silence continues for approx. 2 seconds during
VAS recording, the recording is paused. Then,
FOLDER
the recording indicator, "VAS" and "*" will blink.
●
For important recording, set the VAS setting to "
●
Using the LOW CUT FILTER will cut low frequency sound and VAS recording may not be
performed properly. In this case, cancel the LOW CUT FILTER setting. (➜ page16)
●
If [* REC] is pressed while VAS recording is being paused, the unit will enter normal recording
pause state and only "VAS" will light up.
" and press
".)
"VAS" is displayed.
Adjusting the VAS operation level:
Press u, i during VAS recording.
(The factory setting is "
●
You can adjust the sound detection level from
1 to 5.
●
If the sound to record is low, increase the VAS
value (sensitivity level). If the sound is loud,
decrease the VAS value.
".
".)
17
17