Gluing Instructions - Megasat Caravanman 65 Premium Mode D'emploi

2. Installation
5. Roughen the drawn areas and feet with sandpaper (120 grit) to easily and thoroughly
clean the surface again with cleaner (WARNING: then no longer touch areas) and let
the clean dry for about 10 minutes.

2.2 Gluing instructions

1. Prepare the glue for mounting.
2. Now take the glue on the underside of the antenna base in
serpentine lines, so that the glue can harden well to the inside.
3. Now place immediately (within 5 minutes after adhesive application), the antenna
on the marked fields. Press your feet slightly and evenly and fix the antenna so that it
stays in place, eg by an adhesive tape. It must be after pressing for at least 2 mm glue
between antenna and surface. The adhesive is cured max. in 48 hours at +18° C and a
relative humidity of 50%. Should prevail low humidity during the assembly time, spray
after bonding in the vicinity of the antenna always some water in the air.
4. Remove any spilled adhesive immediately with a putty knife or similar and clean the
soiled surfaces with the cleaner and a fleece cloth.
5. For safety, you can attach the antenna base additionally. Given by drill through the
existing hole in the respective antenna to the roof of your car and fix it with a screw
with locking nut. In order for the freshly bonded feet can not slip, wait with this work
until the adhesive has cured.
6. After the complete assembly and curing of the adhesive, a silicone can be drawn
around the antenna bases.
06
ENGLISH
2. Installation
2.3 Installation of the roof outlet
1. If you have no way to feed the cable through
an existing Roof outlet, seek a suitable place
(best in the slipstream behind the antenna)
on the roof for the installation of the Roof
outlet to prevent ingress of moisture (eg rain
or splashing) in to avoid borehole. Make sure
that the cable is not bent too much signal
loss and to avoid damaging the cable (ben-
ding radius max. 5-7 cm).
2. To install the weatherproof housing for the
cable connector, glue as described above,
the base plate to a suitable location of your
vehicle. Connect the connecting cable and
insert it into the slot provided. Now put the
cover on the base plate and fix it with the
screws. Seal openings here both with the
weather-resistant silicone material.
The Roof outlet taped as the anten-
na itself on the vehicle roof.
After installation the roof outlet,
the opening must be sealed with
weather-resistant silicone.
ENGLISH
07