Installation Indoors; Installation Of The Dish; Connection Diagram - Megasat Caravanman 65 Premium Mode D'emploi

2. Installation

2.4 Installation indoors

1. The control cable and coaxial cable is routed inside the vehicle.
IMPORTANT: The control cable must not be shortened.
2. Make sure when you choosing a location for the control unit and the set-top box
that both devices are in a dry and a protected place.
3. Do not place the control unit and the set-top box close to heat sources and ensure
sufficient ventilation.
4. Below are the basic connections for the antenna system are shown:
• Connect the power supply (red and black thick cable) for the control unit to your
car battery via a fuse (7 amps) to avoid a cable fire at short circuit. The yellow cable
is connected to the ignition plus of the vehicle (12 volts line only when the ignition
leads), and also protected with a fuse of 7 amps. The remaining black wire is connec-
ted to the corresponding negative (ground).
• Connect the cables coming from the antenna to the control unit:
- 7 m Control cable with green connector into „CONTROL CONNECTOR"
- 10 m Coaxial cable with F-connector in „ANTENNA"
• Connect the control unit to the set-top box:
- 1,5 m Kcoaxial cable with F-connector from „RECEIVER" to set-top box.

2.5 Installation of the dish

1. Turn on the control unit.
2. Press the SEARCH button and wait until the back part of the antenna is erected.
3. Remove the power supply to the control unit - the search is interrupted and you can
now assembly the dish.
4. After assembly the dish you can connect the power supply back on and start a normal scan.
08
ENGLISH
2. Installation

2.6 Connection diagram

Ignition positive
The Caravanman automatically moves to the folded state when the ignition key is turned.
This function is only available when the controller is turned off and cables
are connected. The control unit displayed „IGNITION".
(+) (-)
5 1 2
6
5
4
Control unit
(-) (+)
Power supply
12 V DC via battery (positive-permanent
systems) or optional DC power supply
230 V / 12 V (no charger). Ensure that a
current is assured of at least 5 amps.
Note
The control cable (7 m) can not
be reduced, because that can cause
interference.
1
Control cable 7 m
2
Coaxial cable 10 m
3
Coaxial cable 1 m
4
Positive pole
5
Minus pol
6
Plus ignition
5
Second connection
only at Caravanman 85
Professional / GPS
3
not
3
included
Television 1
Television 2
Information:
The antenna does not have to
necessarily be operated with
two receivers!
ENGLISH
6
and
09