Simu GM800 Notice D'installation page 20

8
Setup and operating options
General setup diagram
Meanings of the various parameters
CODE DESCRIPTION
P0
Obstacle detection sensitivity
P1
Closure approach speed
Memorising the remote control for controlling lighting
Memorising the remote control for partial opening cycle
Clearing remote controls
- Press the button until the light blinks (7 s). This clears all of the
remote controls memorised.
Resetting all settings
- Press the button until the light goes out (7 s). This clears all previously stored settings and returns them to their
default values.
Locking programming
- The keypad must be locked to ensure the safety of the users. Simultaneously press the
- Start by pressing . Pressing
any effect. The remote control memorising functions (
possible. To access programming mode once again, repeat the same procedure.
9
Re-fi tting covers - Antenna orientation
- Position the aerial and fi t the covers.
* To ensure proper remote control range, the aerial must
be fi tted in one of the two positions shown deside.
8
X
VALUES
1
very low sensitivity
2
low sensitivity
3
4
1
no slowdown
2
short soft stop (default setting)
3
and must take place within two seconds. Pressing the
button) and forced mode operation (
X+1
X
X-1
Standard (default setting)
high sensitivity
long soft stop
2 s. 1 s.
2 s.
7 s.
, and
button then no longer has
X+1
X-1
COMMENTS
If this parameter is modified, the installer must check that
the limitation of forces complies with appendix A of
the standard EN 12 453.
P1=1 no slowdown before closure
P1=2 speed is reduced during the last 20 centimetres.
P1=3 speed is reduced during the last 50 centimetres.
If this parameter is modified, the installer must check that the limitation
of forces complies with appendix A of the standard EN 12 453.
x1 1 s. x2
1 s. x1
.
and buttons) remain
1
*
3
5 s.
5 s.
...
7 s.
2 s. max.
+ +
2
4