AERMEC FCLMC20 Mode D'emploi page 6

FCLMC20
Fig. 4
Fig. 5
Fig. 6
4
AFCLMC20UJ_ 6204350_01
.
Installation of the accessory
Only FCLI: accessory FCLMC20IK must already be in
stalled on FCLI (see the manual of the accessory). (fig. 4)
.
The unit cassette FCL-FCLI must already be installed (see
the manual installation and use). (fig. 5)
.
Connect all the plumbing, electrical and condensate
drain. The electrical and plumbing connections must
come from the top or from the passage arranged on the
mantle, must not interfere with the cape.
.
Apply the accessory unit FCLMC20 cassettes. Align the
holes in the two brackets of the coat with the holes in
the brackets of the boxes, fixing them with 4 screws
(supplied) using a long screwdriver. (fig. 6)
.
Continue with the installation of the grid (GLL / GLLI) as a
normal procedure given in the manual.
MAINTENANCE.
To clean the case and the visible part of the fan coil, use soft
cloths or sponges dampened in water at maximum temperature
of 40°C. Do not use chemical products or solvents on any part of
the fan coil. Do not spray water on interior or exterior surfaces of
the fan coil (danger of short circuits).
GENERAL WARNINGS.
Store them in a dry place to avoid deterioration for at least 10
years for future reference. Read carefully and thoroughly all the
information contained in this manual. Pay particular attention
to the rules of use accompanied by the words "DANGER" or
"WARNING" in that, if not observed, can cause damage to the
machine and / or personal injury.