Orbis VIARIS COMBI Mode D'emploi page 69

TROUBLESHOOTING
Problem
The charger is powered and no plug
connected and with the light indicators
off.
Charger connected to the vehicle, the
status bar is green fixed and does not
charge.
Charger connected to the vehicle, the
status bar is in blinking green and
does not charge.
Charger connected to the vehicle, the
status bar is in blinking green and
when the RFID
charger make 5 "bips" and the status
bar flashes in red and returns to fixed
green.
Charger connected to the vehicle, the
status bar is blue fixed and does not
charge.
Charger connected to the vehicle, the
status bar is in blue of varying
intensity and does not charge.
Charger connected to the vehicle, the
status bar is in blinking blue and does
not charge.
Charger connected to the vehicle, the
status bar is fixed red and does not
charge.
Charger connected to the vehicle, the
status bar is fixed blank and does not
load.
card passes the
Resolution
Check the power according to the
connection scheme
protections are activated.
Wait approximately the 10 seconds the
charger requires to boot.
There is no communication between the
vehicle and the charger; check the hose
and correctly inserted into the vehicle and
charger.
The charger is not authorized to load;
pass the authorized RFID card.
The RFID card is not authorized. Check
the list of authorized cards.
Check that there is no time schedule on
either the charger (
The vehicle may be in standby mode.
Open the vehicle door to exit the standby
mode.
The charge modulator indicator
the installation does not have sufficient
power to load the vehicle.
The vehicle has finished charging; check
that the battery is full or that the vehicle
has no time schedule.
Error; turn off the charger from the
protections and switch back on.
Reserved State, e.g. in an up-to-date
situation; wait till the reserved state ends.
21
and that the
) or the vehicle.
is on;